REMOVAL
(1) Disconnect negative battery cable at battery.
(2) Disconnect vacuum hose (line) at servo (Fig. 1).
(3) Disconnect electrical connector at servo.
(4) Disconnect servo cable at throttle body. Refer to Servo Cable Removal/Installation in this group.
(5) Remove 2 mounting nuts holding servo cable sleeve to bracket (Fig. 1) or (Fig. 2).
(6) Pull speed control cable sleeve and servo away from servo mounting bracket to expose cable retaining clip (Fig. 2) and remove clip. Note: The servo mounting bracket displayed in (Fig. 2) is a typical bracket and may/may not be applicable to this model vehicle.
(7) Remove servo from mounting bracket. While removing, note orientation of servo to bracket.
INSTALLATION
(1) Position servo to mounting bracket.
(2) Align hole in cable connector with hole in servo pin. Install cable-to-servo retaining clip.
(3) Insert servo mounting studs through holes in servo mounting bracket.
(4) Install servo mounting nuts and tighten to 8.5 N*m (75 in. lbs.).
(5) Connect vacuum line at servo.
Fig. 1 Speed Control Servo Location
1 - SPEED CONTROL SERVO
2 - VACUUM HOSE
3 - SERVO BRACKET NUTS (2)
4 - SERVO CABLE
5 - CABLE SLEEVE
6 - SERVO MOUNTING NUTS (2)
7 - ELECTRICAL CONNECTOR
Fig. 2 Servo Cable Clip Remove/Install-Typical
1 - SERVO MOUNTING NUTS (2)
2 - SERVO
3 - CABLE RETAINING CLIP
4 - SERVO CABLE AND SLEEVE
(6) Connect electrical connector at servo.
(7) Connect servo cable to throttle body. Refer to Servo Cable Removal/Installation in this group.
(8) Connect negative battery cable to battery.
(9) Before starting engine, operate accelerator pedal to check for any binding.