Dodge Durango

 Service Manual

Speed Control System » Removal and installation
Servo cable (except 4.7L engine)

REMOVAL

(1) Disconnect negative battery cable at battery.

(2) Using finger pressure only, remove speed control cable connector at throttle body bellcrank by pushing connector off the bellcrank pin (Fig. 4). DO NOT try to pull connector off perpendicular to the bellcrank pin. Connector will be broken.

Fig. 4 Cable Connection at Throttle Body

1 - VEHICLE SPEED CONTROL CABLE

(3) Squeeze 2 tabs on sides of speed control cable at throttle body mounting bracket (locking plate) and push out of bracket.

(4) Remove servo cable from servo. Refer to Speed Control Servo Removal/Installation in this group.

INSTALLATION

(1) Install end of cable to speed control servo.

Refer to Speed Control Servo Removal and Installation in this group.

(2) Install cable into throttle body mounting bracket (snaps in).

(3) Install speed control cable connector at throttle body bellcrank pin (snaps on).

(4) Connect negative battery cable at battery.

(5) Before starting engine, operate accelerator pedal to check for any binding.

Speed control servo

Speed control switches

Servo cable (except 4.7L engine)

Servo cable-4.7L v-8 engine

Vacuum reservoir