Toyota
Dodge Durango
 Service Manual
Ignition System » Removal and installation
Camshaft position sensor

The camshaft position sensor is located in the distributor on all 3.9L V-6 and 5.2/5.9L V-8 engines (Fig.

29).

REMOVAL

Distributor removal is not necessary to remove camshaft position sensor.

(1) Remove air cleaner assembly.

(2) Disconnect negative cable from battery.

(3) Remove distributor cap from distributor (two screws).

(4) Disconnect camshaft position sensor wiring harness from main engine wiring harness.

(5) Remove distributor rotor from distributor shaft.

(6) Lift the camshaft position sensor assembly from the distributor housing (Fig. 29).

INSTALLATION

(1) Install camshaft position sensor to distributor.

Align sensor into notch on distributor housing.

(2) Connect wiring harness.

(3) Install rotor.

(4) Install distributor cap. Tighten mounting screws.

Fig. 29 Camshaft Position Sensor Fig. 29 Camshaft Position Sensor

1 - SYNC SIGNAL GENERATOR

2 - CAMSHAFT POSITION SENSOR

3 - PULSE RING

4 - DISTRIBUTOR ASSEMBLY

(5) Install air cleaner assembly.

    More about «Removal and installation»:

    Spark plug cables

    Spark plugs

    Ignition coil-3.9/5.2/5.9L engines

    Ignition coil-4.7L engine

    Crankshaft position sensor-3.9/5.2/ 5.9L engines

    Crankshaft position sensor-4.7L v-8 engine

    Camshaft position sensor

    Camshaft position sensor-4.7L engine

    Distributors-3.9/5.2/5.9L engines

    Ignition switch and key cylinder

    Column shift interlock

    Dodge Durango Service Manual / Ignition System / Removal and installation / Camshaft position sensor

    Dodge Durango Service Manual

    Categories


    © 2017-2023 Copyright www.dodurango.net
    0.0174