Dodge Durango Service ManualTransmission and Transfer Case » Removal and installation
Park/neutral position switch
Dodge Durango
Service Manual
Park/neutral position switch
REMOVAL
(1) Raise vehicle and position drain pan under switch.
(2) Disconnect switch wires.
(3) Remove switch from case.
INSTALLATION
(1) Move shift lever to Park and Neutral positions.
Verify that switch operating lever fingers are centered in switch opening in case (Fig. 79).
(2) Install new seal on switch and install switch in case. Tighten switch to 34 N*m (25 ft. lbs.) torque.
(3) Test continuity of new switch with 12V test lamp.
(4) Connect switch wires and lower vehicle.
(5) Top off transmission fluid level.
More about «Removal and installation»:
Transmission
Torque converter
Yoke seal replacement
Park/neutral position switch
Gearshift cable
Governor solenoid and pressure sensor
Valve body
Overdrive unit
Overdrive housing bushing
Output shaft rear bearing
Output shaft front bearing
Dodge Durango Service Manual / Transmission and Transfer Case / Removal and installation / Park/neutral position switch
Dodge Durango Service Manual
- Lubrication and Maintenance
- Suspension
- Differential and Driveline
- Brakes
- Cooling System
- Battery
- Starting Systems
- Charging System
- Ignition System
- Instrument Panel Systems
- Audio Systems
- Horn Systems
- Speed Control System
- Turn Signal and Hazard Warning Systems
- Wiper and Washer Systems
- Lamps
- Passive Restraint Systems
- Electrically Heated Systems
- Power Distribution System
- Power Lock Systems
- Vehicle Theft/Security Systems
- Power Seat System
- Power Window Systems
- Power Mirror Systems
- Chime/Buzzer Warning Systems
- Overhead Console Systems
- Engine
- Exhaust System
- Frame and Bumpers
- Fuel System
- Steering
- Transmission and Transfer Case
- Tires and Wheels
- Body
- Heating and Air Conditioning
- Emission Control Systems
- Introduction
Categories
© 2017-2024 Copyright www.dodurango.net
0.0217
0.0217