Toyota
Dodge Durango
 Service Manual
Instrument Panel Systems » Removal and installation
Glove box lamp and switch

WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, REFER TO GROUP 8M - PASSIVE RESTRAINT SYSTEMS BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.

REMOVAL

(1) Disconnect and isolate the battery negative cable.

(2) Open the glove box.

(3) Reach through the glove box opening and behind the glove box opening upper reinforcement in the instrument panel to access and depress the retaining latches on the top and bottom of the glove box lamp and switch housing.

(4) While holding the retaining latches depressed, push the glove box lamp and switch out through the mounting hole in the instrument panel glove box opening upper reinforcement (Fig. 17).

(5) Pull the glove box lamp and switch out from the mounting hole far enough to access the wire harness connector.

(6) Disconnect the instrument panel wire harness connector from the glove box lamp and switch connector receptacle.

(7) Remove the glove box lamp and switch from the instrument panel.

Fig. 17 Glove Box Lamp and Switch Remove/Install Fig. 17 Glove Box Lamp and Switch Remove/Install

1 - GLOVE BOX LAMP AND SWITCH

2 - CONNECTOR

INSTALLATION

(1) Position the glove box lamp and switch to the instrument panel.

(2) Reconnect the instrument panel wire harness connector to the glove box lamp and switch connector receptacle.

(3) Feed the instrument panel wire harness back into the glove box lamp and switch mounting hole in the glove box opening upper reinforcement.

(4) Align the glove box lamp and switch housing with the mounting hole in the instrument panel glove box opening upper reinforcement.

(5) Push the glove box lamp and switch into the mounting hole in the instrument panel glove box opening upper reinforcement until the retaining latches are fully engaged.

(6) Close the glove box.

(7) Reconnect the battery negative cable.

    More about «Removal and installation»:

    Cluster bezel

    Headlamp switch

    Instrument cluster

    Instrument cluster components

    Steering column opening cover

    Gear selector indicator

    Park brake release handle

    Instrument panel lower reinforcement

    Instrument panel center support bracket

    Instrument panel ash receiver

    Instrument panel lower bezel

    Instrument panel cigar lighter and power outlet

    Glove box lamp and switch

    Glove box latch striker

    Glove box

    Glove box components

    Central timer module

    Instrument panel assembly

    Instrument panel top cover

    Dodge Durango Service Manual / Instrument Panel Systems / Removal and installation / Glove box lamp and switch

    Dodge Durango Service Manual

    Categories


    © 2017-2024 Copyright www.dodurango.net
    0.0082