Toyota
Dodge Durango
 Service Manual
Instrument Panel Systems » Removal and installation
Glove box components

The only serviced component of the glove box is the glove box bin. If any other component of the glove box is faulty or damaged, the entire glove box assembly must be replaced.

WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, REFER TO GROUP 8M - PASSIVE RESTRAINT SYSTEMS BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.

REMOVAL

GLOVE BOX BIN

(1) Disconnect and isolate the battery negative cable.

(2) Remove the glove box from the instrument panel. Refer to Glove Box - Removal in the Removal and Installation section of this group for the procedures.

(3) Remove the two screws that secure each outboard flange of the glove box bin to the glove box door (Fig. 21).

Fig. 21 Glove Box Components Remove/Install Fig. 21 Glove Box Components Remove/Install

1 - LATCH

2 - STOP BUMPERS

3 - BIN

4 - DOOR

(4) Remove the two remaining screws in the bottom of the glove box bin (the center screw was removed during glove box removal) that secure the bin to the bottom of the glove box door.

(5) Remove the four screws that secure the top of the glove box bin and the glove box latch to the glove box door.

(6) Remove the glove box bin and the glove box latch from the glove box door.

INSTALLATION

GLOVE BOX BIN

(1) Position the glove box latch and the glove box bin to the glove box door.

(2) Install and tighten the four screws that secure the top of the glove box bin and the glove box latch to the glove box door. Tighten the screws to 2.2 N*m (20 in. lbs.).

(3) Install and tighten the two outboard screws in the bottom of the glove box bin (the center screw will be installed following glove box installation) that secure the bin to the bottom of the glove box door.

Tighten the screws to 2.2 N*m (20 in. lbs.).

(4) Install and tighten the two screws that secure each outboard flange of the glove box bin to the glove box door. Tighten the screws to 2.2 N*m (20 in. lbs.).

(5) Install the glove box onto the instrument panel.

Refer to Glove Box - Installation in the Removal and Installation section of this group for the procedures.

(6) Reconnect the battery negative cable.

    More about «Removal and installation»:

    Cluster bezel

    Headlamp switch

    Instrument cluster

    Instrument cluster components

    Steering column opening cover

    Gear selector indicator

    Park brake release handle

    Instrument panel lower reinforcement

    Instrument panel center support bracket

    Instrument panel ash receiver

    Instrument panel lower bezel

    Instrument panel cigar lighter and power outlet

    Glove box lamp and switch

    Glove box latch striker

    Glove box

    Glove box components

    Central timer module

    Instrument panel assembly

    Instrument panel top cover

    Dodge Durango Service Manual / Instrument Panel Systems / Removal and installation / Glove box components

    Dodge Durango Service Manual

    Categories


    © 2017-2023 Copyright www.dodurango.net
    0.0457