Floor carpet. Rearview mirror

Floor carpet

FRONT CARPET REMOVAL

(1) Remove floor console, if equipped.

(2) Remove front seats.

(3) Remove center console, if equipped.

(4) Remove 2nd row seats.

(5) Remove 3rd row seats, if equipped.

(6) Remove front and rear door sill trim.

(7) Remove lower left and right cowl trim.

(8) Remove left and right B-pillar trim.

(9) Remove left and right quarter panel trim.

(10) Loosen gas pedal bracket.

(11) Remove rear fresh air vent.

(12) Route wiring through carpet.

(13) Remove carpet from vehicle (Fig. 99).

FRONT CARPET INSTALLATION

(1) Position carpet in vehicle and align all holes.

(2) Route all wire harnesses through openings in carpet.

(3) Install front and rear door sill trim.

(4) Install quarter panel trim.

(5) Install B-pillar trim.

(6) Install lower cowl trim.

(7) Tighten gas pedal bracket.

(8) Install 3rd row seats, if equipped.

(9) Install 2nd row seats.

(10) Install rear fresh air vent.

(11) Install center console, if equipped.

(12) Install front seats.

(13) Install floor console, if equipped.

REAR CARPET REMOVAL

(1) Remove 3rd row seats, if equipped.

(2) Remove 3rd row seat belt/buckles, if equipped.

(3) Remove left and right quarter panel trim.

(4) Remove liftgate scuff plate.

(5) Remove screws attaching cargo compartment lid hinge to floor.

(6) Remove carpet from vehicle (Fig. 99).

REAR CARPET INSTALLATION

(1) Position carpet in vehicle and align all holes.

(2) Install screws attaching cargo compartment lid hinge to floor.

(3) Install liftgate scuff plate.

(4) Install quarter panel trim.

(5) Install 3rd row seat belt/buckles, if equipped.

(6) Install 3rd row seats, if equipped.

Fig. 99 Floor Carpet

1 - FRONT CARPET

2 - REAR CARPET

3 - STORAGE COMPARTMENT LINER

4 - PLASTIC PUSH-IN NUT

Floor cargo storage door

The floor cargo storage door is attached to the cargo area carpet. Refer to Floor Carpet for service procedures.

Rearview mirror

REMOVAL

(1) Loosen the mirror base setscrew (Fig. 100).

(2) Slide the mirror base upward and off the bracket.

Fig. 100 Rearview Mirror

1 - MIRROR

2 - SUPPORT BUTTON

INSTALLATION

(1) Position the mirror base at the bracket and slide it downward onto the support bracket.

(2) Tighten setscrew to1 N*m (9 in. lbs.) torque.