REMOVAL
(1) Disconnect and isolate the battery negative cable.
(2) Unplug the wire harness connector from the electronic cycling clutch switch near the expansion valve (Fig. 49).
Fig. 49 Electronic Cycling Clutch Switch Remove/ Install
1 - ELECTRONIC CYCLING CLUTCH SWITCH
2 - WIRE HARNESS CONNECTOR
3 - EXPANSION VALVE
4 - FASTENER
(3) Remove and discard the fastener that secures the electronic cycling clutch switch to the outboard side of the expansion valve.
(4) Pull the electronic cycling clutch switch away from the side of the expansion valve far enough for the thermistor probe capillary tube to clear the well in the expansion valve. The washer bottle may have to be removed.
NOTE: The capillary tube well in the expansion valve is filled with a special thermally-conductive grease. This grease should be removed from the old parts and reused on the new parts whenever the electronic cycling clutch switch or the expansion valve are replaced.
INSTALLATION
(1) Insert the thermistor probe capillary tube of the electronic cycling clutch switch into the well on the outboard side of the expansion valve.
(2) Install the electronic cycling clutch switch to the expansion valve and secure it with a new fastener.
(3) Plug the wire harness connector into the electronic cycling clutch switch.
(4) Connect the battery negative cable.