Toyota
Dodge Durango
 Service Manual
Ignition System » Removal and installation
Crankshaft position sensor-3.9/5.2/ 5.9L engines

REMOVAL

The sensor is bolted to the top of the cylinder block near the rear of right cylinder head (Fig. 27). The sensor is accessed by removing the right front fender liner.

(1) Remove right front tire and right front wheelhouse liner. Refer to Front Wheelhouse Liner in Group 23, Body.

(2) Disconnect crankshaft position sensor pigtail harness from main wiring harness.

(3) Remove two sensor (recessed hex head) mounting bolts (Fig. 27).

(4) Remove sensor from engine.

INSTALLATION

(1) Position crankshaft position sensor to engine.

(2) Install mounting bolts and tighten to 8 N*m (70 in. lbs.) torque.

(3) Connect main harness electrical connector to sensor.

(4) Install right front tire and right front wheelhouse liner. Refer to Front Wheelhouse Liner in Group 23, Body.

Fig. 27 Crankshaft Position Sensor-3.9/5.2/5.9L Engines Fig. 27 Crankshaft Position Sensor-3.9/5.2/5.9L Engines

1 - GROMMET

2 - MOUNTING BOLTS (2)

3 - CRANKSHAFT POSITION SENSOR

4 - RIGHT EXHAUST MANIFOLD

5 - TRANSMISSION BELL HOUSING

    More about «Removal and installation»:

    Spark plug cables

    Spark plugs

    Ignition coil-3.9/5.2/5.9L engines

    Ignition coil-4.7L engine

    Crankshaft position sensor-3.9/5.2/ 5.9L engines

    Crankshaft position sensor-4.7L v-8 engine

    Camshaft position sensor

    Camshaft position sensor-4.7L engine

    Distributors-3.9/5.2/5.9L engines

    Ignition switch and key cylinder

    Column shift interlock

    Dodge Durango Service Manual / Ignition System / Removal and installation / Crankshaft position sensor-3.9/5.2/ 5.9L engines

    Dodge Durango Service Manual

    Categories


    © 2017-2024 Copyright www.dodurango.net
    0.0214