
Dodge Durango
Owners Manual
Understanding the features of your vehicle » Garage door opener - if equipped
Before You Begin Programming HomeLink
Be sure that your vehicle is parked outside of the garage
before you begin programming.
For more efficient programming and accurate transmission
of the radio-frequency signal, it is recommended
that a new battery be placed in the hand-held transmitter
of the device that is being programmed to the HomeLink
system.
To erase the channels, place the ignition in the ON/RUN
position and push and hold the two outside HomeLink
buttons (I and III) for up 20 seconds or until the red
indicator flashes.
NOTE:
- Erasing all channels should only be performed when
programming HomeLink for the first time. Do not
erase channels when programming additional buttons.
- If you have any problems, or require assistance, please
call toll-free 1-800-355-3515 or, on the Internet at
HomeLink.com for information or assistance.
More about «Garage door opener - if equipped»:
Before You Begin Programming HomeLink