Toyota
Dodge Durango
 Service Manual
Transmission and Transfer Case » Removal and installation
Overdrive housing bushing

REMOVAL

(1) Remove overdrive housing yoke seal.

(2) Insert Remover 6957 into overdrive housing.

Tighten tool to bushing and remove bushing (Fig.

95).

INSTALLATION

(1) Align bushing oil hole with oil slot in overdrive housing.

Fig. 95 Bushing Removal-Typical Fig. 95 Bushing Removal-Typical

1 - REMOVER 6957

2 - EXTENSION HOUSING BUSHING

(2) Tap bushing into place with Installer 6951 and Handle C-4171.

(3) Install new oil seal in housing using Seal Installer C-3995-A (Fig. 96).

Fig. 96 Overdrive Housing Seal Installation Fig. 96 Overdrive Housing Seal Installation

1 - SPECIAL TOOL C-3995-A OR C-3972-A

2 - SPECIAL TOOL C-4471

    More about «Removal and installation»:

    Transmission

    Torque converter

    Yoke seal replacement

    Park/neutral position switch

    Gearshift cable

    Governor solenoid and pressure sensor

    Valve body

    Overdrive unit

    Overdrive housing bushing

    Output shaft rear bearing

    Output shaft front bearing

    Dodge Durango Service Manual / Transmission and Transfer Case / Removal and installation / Overdrive housing bushing

    Dodge Durango Service Manual

    Categories


    © 2017-2019 Copyright www.dodurango.net
    0.0046