Toyota
Dodge Durango
 Service Manual
Transmission and Transfer Case » Removal and installation
Governor solenoid and pressure sensor

REMOVAL

(1) Hoist and support vehicle on safety stands.

(2) Remove transmission fluid pan and filter.

(3) Disengage wire connectors from pressure sensor and solenoid (Fig. 83).

(4) Remove screws holding pressure solenoid retainer to governor body.

(5) Separate solenoid retainer from governor (Fig.

84).

(6) Pull solenoid from governor body (Fig. 85).

(7) Pull pressure sensor from governor body.

(8) Remove bolts holding governor body to valve body.

(9) Separate governor body from valve body (Fig.

86).

(10) Remove governor body gasket.

INSTALLATION

Before installing the pressure sensor and solenoid in the governor body, replace O-ring seals, clean the gasket surfaces and replace gasket.

(1) Place gasket in position on back of governor body (Fig. 86).

(2) Place governor body in position on valve body.

(3) Install bolts to hold governor body to valve body.

(4) Lubricate O-ring on pressure sensor with transmission fluid.

(5) Align pressure sensor to bore in governor body.

(6) Push pressure sensor into governor body.

(7) Lubricate O-ring, on pressure solenoid, with transmission fluid.

(8) Align pressure solenoid to bore in governor body (Fig. 85).

(9) Push solenoid into governor body.

(10) Place solenoid retainer in position on governor (Fig. 84).

(11) Install screws to hold pressure solenoid retainer to governor body.

(12) Engage wire connectors into pressure sensor and solenoid (Fig. 83).

(13) Install transmission fluid pan and (new) filter.

(14) Lower vehicle and road test to verify repair.

    More about «Removal and installation»:

    Transmission

    Torque converter

    Yoke seal replacement

    Park/neutral position switch

    Gearshift cable

    Governor solenoid and pressure sensor

    Valve body

    Overdrive unit

    Overdrive housing bushing

    Output shaft rear bearing

    Output shaft front bearing

    Dodge Durango Service Manual / Transmission and Transfer Case / Removal and installation / Governor solenoid and pressure sensor

    Dodge Durango Service Manual

    Categories


    © 2017-2019 Copyright www.dodurango.net
    0.0044