Dodge Durango

 Service Manual

Transmission and Transfer Case » Removal and installation
Yoke seal replacement

REMOVAL

(1) Raise vehicle.

(2) Mark propeller shaft and axle yoke for alignment reference.

(3) Disconnect and remove propeller shaft.

(4) Remove old seal with Seal Remover C-3985-B (Fig. 77) from overdrive housing.

INSTALLATION

(1) Place seal in position on overdrive housing.

(2) Drive seal into overdrive housing with Seal Installer C-3995-A (Fig. 78).

(3) Carefully guide propeller shaft slip yoke into housing and onto output shaft splines. Align marks made at removal and connect propeller shaft to rear axle pinion yoke.

Fig. 77 Removing Overdrive Housing Yoke Seal

1 - SPECIAL TOOL C-3985-B

2 - SEAL

Fig. 78 Installing Overdrive Housing Yoke Seal

1 - SPECIAL TOOL C-3995-A OR C-3972-A

2 - SPECIAL TOOL C-4471

Transmission

Torque converter

Yoke seal replacement

Park/neutral position switch

Gearshift cable

Governor solenoid and pressure sensor

Valve body

Overdrive unit

Overdrive housing bushing

Output shaft rear bearing

Output shaft front bearing