Dodge Durango Service ManualWiper and Washer Systems » Description and operation
Washer fluid level sensor
Washer fluid level sensor
The standard washer fluid level sensor is mounted on the right outboard end of the upper radiator shroud near the front of the windshield washer reservoir.
A barbed nipple on the sensor is press-fit into a rubber grommet seal installed in a hole in the side of the reservoir.
When the fluid level in the reservoir falls below the pivoting float on the sensor, the float changes position and closes the internal switch contacts of the sensor. Refer to Low Washer Fluid Warning Lamp in the Diagnosis and Testing section of Group 8E - Instrument Panel Systems for diagnosis of the low washer fluid warning lamp and circuit, including the sensor.
The washer fluid level sensor cannot be repaired. If faulty or damaged, the sensor unit must be replaced.
Wiper arm and blade
Wiper linkage and pivot
Wiper motor
Wiper switch and washer switch
Central timer module
Intermittent wipe relay
Washer reservoir
Washer pump
Washer fluid level sensor
Washer nozzle and plumbing
Dodge Durango Service Manual
- Lubrication and Maintenance
- Suspension
- Differential and Driveline
- Brakes
- Cooling System
- Battery
- Starting Systems
- Charging System
- Ignition System
- Instrument Panel Systems
- Audio Systems
- Horn Systems
- Speed Control System
- Turn Signal and Hazard Warning Systems
- Wiper and Washer Systems
- Lamps
- Passive Restraint Systems
- Electrically Heated Systems
- Power Distribution System
- Power Lock Systems
- Vehicle Theft/Security Systems
- Power Seat System
- Power Window Systems
- Power Mirror Systems
- Chime/Buzzer Warning Systems
- Overhead Console Systems
- Engine
- Exhaust System
- Frame and Bumpers
- Fuel System
- Steering
- Transmission and Transfer Case
- Tires and Wheels
- Body
- Heating and Air Conditioning
- Emission Control Systems
- Introduction
Categories
0.0069