Transfer Case
Fluid Level Check
For normal service, periodic fluid level checks are not
required. When the vehicle is serviced for other reasons
the exterior surfaces of the transfer case assembly should
be inspected. If oil leakage is suspected inspect the fluid level. Refer to
"Fluids, Lubricants, and Genuine Parts" in
"Maintaining Your Vehicle" for further information.
Adding Fluid
Add fluid at the filler hole, until it runs out of the hole,
when the vehicle is in a level position.
Drain
First remove fill plug, then remove drain plug. Recommended
tightening torque for drain and fill plugs is 15 to
25 ft lbs (20 to 34 N·m).
| CAUTION!
When installing plugs, do not overtighten. You could
damage them and cause them to leak. |
Selection Of Lubricant
Use only the manufacturer's recommended fluid. Refer
to "Fluids, Lubricants, and Genuine Parts" in "Maintaining
Your Vehicle" for further information.
Automatic Transmission
Selection Of Lubricant
It is important to use the proper transmission fluid to
ensure optimum transmission performance and life. Use
only the manufacturer's specified transmission fluid.
Refer to "Fluids, Lubricants, and Genuine Parts" in this
section for fluid specifications. It is important to maintain
the transmission fluid at the correct level using the
recommended fluid.
NOTE: No chemical flushes should be used in any
transmission; only the approved lubricant should be
used.
| CAUTION!
Using a transmission fluid other than the manufacturer's
recommended fluid may cause deterioration
in transmission shift quality and/or torque converter
shudder. Refer to "Fluids, Lubricants, And Genuine
Parts" in this section for fluid specifications. |
Special Additives
The manufacturer strongly recommends against using
any special additives in the transmission.
Automatic Transmission Fluid (ATF) is an engineered
product and its performance may be impaired by supplemental
additives. Therefore, do not add any fluid additives
to the transmission. Avoid using transmission sealers
as they may adversely affect seals.
| CAUTION!
Do not use chemical flushes in your transmission as
the chemicals can damage your transmission components. Such damage is not covered by the New
Vehicle Limited Warranty. |
Fluid Level Check
The fluid level is preset at the factory and does not
require adjustment under normal operating conditions.
Routine fluid level checks are not required, therefore the
transmission has no dipstick. Your authorized dealer can
check your transmission fluid level using special service
tools.
If you notice fluid leakage or transmission malfunction,
visit your authorized dealer immediately to have the
transmission fluid level checked. Operating the vehicle with an improper fluid
level can cause severe transmission
damage.
| CAUTION!
If a transmission fluid leak occurs, visit your authorized
dealer immediately. Severe transmission damage
may occur. Your authorized dealer has the proper
tools to adjust the fluid level accurately. |
Fluid And Filter Changes
Under normal operating conditions, the fluid installed at
the factory will provide satisfactory lubrication for the
life of the vehicle.
Routine fluid and filter changes are not required. However,
change the fluid and filter if the fluid becomes
contaminated (with water, etc.), or if the transmission is
disassembled for any reason.
