Toyota
Dodge Durango
 Service Manual
Engine » Service procedures
Timing chain-measuring wear

NOTE: This procedure must be performed with the timing chain cover removed.

1) Remove the timing chain cover. Refer to Timing Chain Cover in this section for procedure.

(2) To determine if the secondary timing chains are worn, rotate the engine clockwise until maximum tensioner piston extension is obtained. Measure the distance between the secondary timing chain tensioner housing and the step ledge on the piston (Fig.

17). The measurement at point (A) must be less than 15mm (.5906 inches).

(3) If the measurement exceeds the specification the secondary timing chains are worn and require replacement. Refer to Timing Chain and Sprockets in this section for procedure.

    More about «Service procedures»:

    Form-in-place gaskets

    Engine oil

    Repair damaged or worn threads

    Cylinder bore-honing

    Hydrostatic lock

    Valve service

    Engine timing-verification

    Timing chain-measuring wear

    Pistons-fitting

    Piston rings-fitting

    Connecting rod bearings-fitting

    Crankshaft main bearings

    Dodge Durango Service Manual / Engine / Service procedures / Timing chain-measuring wear

    Dodge Durango Service Manual

    Categories


    © 2017-2024 Copyright www.dodurango.net
    0.0225