REMOVAL
(1) Raise and support vehicle.
(2) Remove the upper shock absorber nut, retainer and grommet (Fig. 4).
(3) Remove the lower bolt and remove the shock absorber.
INSTALLATION
NOTE: Upper shock nut must be replaced or use Mopar Lock 'N Seal or LoctiteT 242 on existing nut.
(1) Install the lower retainer (lower retainer is stamped with a L) and grommet on the shock absorber stud. Insert the shock absorber through the frame bracket hole.
(2) Install the lower bolt and tighten the bolt to 108 N*m (80 ft. lbs.).
(3) Install the upper grommet, retainer (upper retainer is stamped with a U) and new nut or use Mopar Lock 'N Seal or Loctitet 242 on existing nut, on the shock absorber stud. Tighten nut to 26 N*m (19 ft. lbs.).
Fig. 4 Shock Absorber
1 - NUT
2 - RETAINER
3 - GROMMET
4 - SHOCK