Toyota
Dodge Durango
 Service Manual
Transmission and Transfer Case » Cleaning and inspection
Rear servo

Remove and discard the servo piston seal ring (Fig.

304). Then clean the servo components with solvent and dry with compressed air. Replace either spring if collapsed, distorted or broken. Replace the plug and piston if cracked, bent, or worn. Discard the servo snap rings and use a new ones at assembly.

Fig. 304 Rear Servo Components Fig. 304 Rear Servo Components

1 - SNAP RING

2 - PISTON SEAL

3 - PISTON PLUG

4 - SPRING RETAINER

5 - SNAP RING

6 - PISTON SPRING

7 - CUSHION SPRING

8 - PISTON

    More about «Cleaning and inspection»:

    Valve body

    Transmission

    Overrunning clutch/low-reverse drum/overdrive piston retainer

    Accumulator

    Front servo

    Rear servo

    Oil pump and reaction shaft support

    Front clutch

    Rear clutch

    Planetary geartrain

    Overdrive unit

    Dodge Durango Service Manual / Transmission and Transfer Case / Cleaning and inspection / Rear servo

    Dodge Durango Service Manual

    Categories


    © 2017-2024 Copyright www.dodurango.net
    0.0073