Programming a non-rolling code. Canadian/Gate Operator Programming

Programming a non-rolling code

For programming Garage Door Openers manufactured before 1995:

1.  Place the ignition in the ON/RUN position.
2.  Place the hand-held transmitter 1 to 3 inches (3 to 8 cm) away from the HomeLink button you wish to program while keeping the HomeLink indicator light in view.
3.  Push and hold the Homelink button you want to program while you push and hold the hand-held transmitter button.
4.  Continue to hold both buttons and observe the indicator light. The Homelink indicator will flash slowly and then rapidly after HomeLink has received the frequency signal from the hand-held transmitter. Release both buttons after the indicator light changes from slow to rapid.
5.  Push and hold the programmed HomeLink button and observe the indicator light.

•  If the indicator light stays on constantly, programming is complete and the garage door/device should activate when the HomeLink button is pushed.
• To program the two remaining HomeLink buttons, repeat each step for each remaining button. DO NOT erase the channels.

Reprogramming A Single HomeLink Button (Non-Rolling Code)

To reprogram a channel that has been previously trained, follow these steps:

1.  Cycle the ignition to the ON/RUN position.
2.  Push and hold the desired HomeLink button until the indicator light begins to flash after 20 seconds. Do not release the button.
3.  Without releasing the button, proceed with "Programming A Non-Rolling Code" step 2 and follow all remaining steps.

Canadian/Gate Operator Programming

For programming transmitters in Canada/United States that require the transmitter signals to "time-out" after several seconds of transmission: Canadian radio frequency laws require transmitter signals to time-out (or quit) after several seconds of transmission, which may not be long enough for HomeLink to pick up the signal during programming. Similar to this Canadian law, some U.S. gate operators are designed to time-out in the same manner.

It may be helpful to unplug the device during the cycling process to prevent possible overheating of the garage door or gate motor.

1.  Cycle the ignition to the ON/RUN position.
2. Place the hand-held transmitter 1 to 3 inches (3 to 8 cm) away from the HomeLink button you wish to program while keeping the HomeLink indicator light in view.
3.  Continue to push and hold the HomeLink button while you push and release ("cycle") your hand-held transmitter every two seconds until HomeLink has successfully accepted the frequency signal. The indicator light will flash slowly and then rapidly when fully trained.
4.  Watch for the HomeLink indicator to change flash rates. When it changes, it is programmed. It may take up to 30 seconds or longer in rare cases. The garage door may open and close while you are programming.
5.  Push and hold the programmed HomeLink button and observe the indicator light.

NOTE:

•  If the indicator light stays on constantly, programming is complete and the garage door/device should activate when the HomeLink button is pushed.
•  To program the two remaining HomeLink buttons, repeat each step for each remaining button. DO NOT erase the channels.

If you unplugged the garage door opener/device for programming, plug it back in at this time.

Reprogramming A Single HomeLink Button (Canadian/Gate Operator)

To reprogram a channel that has been previously trained, follow these steps:

1.  Cycle the ignition to the ON/RUN position.
2. Push and hold the desired HomeLink button until the indicator light begins to flash after 20 seconds. Do not release the button.
3.  Without releasing the button, proceed with "Canadian/Gate Operator Programming" step 2 and follow all remaining steps.