REMOVAL
(1) Remove the serpentine drive belt, refer to Group 7 Cooling.
(2) Clamp the fluid return hose and disconnect the hoses from the power steering pump. Cap the fittings.
(3) Remove battery ground cable and bracket bolts.
(4) Remove the pump assembly (Fig. 3).
(5) Remove the pump pulley, refer to Pump Pulley Removal. This will allow access to the pump attaching screws.
(6) Remove the pump bracket bolts (Fig. 4) and remove the bracket.
INSTALLATION
(1) Install the bracket on the pump and tighten bolts to 41 N*m (30 ft. lbs.).
(2) Install the pump pulley, refer to Pump Pulley Installation.
(3) Install pump assembly on the engine block and tighten the bolts to 41 N*m (30 ft. lbs.).
(4) Install the battery ground wire and tighten nut to 41 N*m (30 ft. lbs.).
(5) Connect the fluid hoses to the pump.
Fig. 3 Pump Assembly
1 - PUMP ASSEMBLY
2 - BOLTS
Fig. 4 Pump Mounting Bracket
1 - PULLEY
2 - PUMP BRACKET
3 - STEERING PUMP
4 - BOLT
(6) Install the serpentine drive belt refer to Group 7 Cooling.
(7) Fill the reservoir with power steering fluid, refer to Power Steering Pump Initial-Operation.