Toyota
Dodge Durango
 Owners Manual
Understanding the features of your vehicle
Parksense rear park assist - if equipped

The ParkSense Rear Park Assist system provides visual and audible indications of the distance between the rear fascia and a detected obstacle when backing up, e.g.

during a parking maneuver. If your vehicle is equipped with an Automatic Transmission, the vehicle brakes may be automatically applied and released when performing a reverse parking maneuver if the system detects a possible collision with an obstacle.

NOTE:

  •  The driver can override the automatic braking function by pressing the gas pedal, turning ParkSense off via ParkSense switch, or changing the gear while the automatic brakes are being applied.
  •  Automatic brakes will not be available if ESC is not available.
  •  Automatic brakes will not be available if there is a faulted condition detected with the ParkSense Park Assist system or the Braking System Module.
  •  The automatic braking function may only be applied if the vehicle deceleration is not enough to avoid colliding with a detected obstacle.
  •  The automatic braking function may not be applied fast enough for obstacles that move toward the rear of the vehicle from the left and/or right sides.
  •  The automatic braking function can be enabled/ disabled from the Customer-Programmable Features section of the Uconnect System.
  •  ParkSense will retain its last known configuration state for the automatic braking function through ignition cycles.

The automatic braking function is intended to assist the driver in avoiding possible collisions with detected obstacles when backing up in REVERSE gear.

NOTE:

  •  The driver is always responsible for controlling the vehicle.
  •  The system is provided to assist the driver and not to substitute the driver.
  •  The driver must stay in full control of the vehicle's acceleration and braking and is responsible for the vehicle's movements.

Refer to ParkSense System Usage Precautions for limitations of this system and recommendations.

ParkSense will retain the last system state (enabled or disabled) from the last ignition cycle when the ignition is changed to the ON/RUN position.

ParkSense can be active only when the gear selector is in REVERSE. If ParkSense is enabled at this gear selector position, the system will remain active until the vehicle speed is increased to approximately 7 mph (11 km/h) or above. When in REVERSE and above the system's operating speed, a warning will appear within the Driver Information Display (DID) indicating the vehicle speed is too fast. The system will become active again if the vehicle speed is decreased to speeds less than approximately 6 mph (9 km/h).

More about «Understanding the features of your vehicle»:

Mirrors

Blind spot monitoring (bsm) - if equipped

Seats

Driver memory seat - if equipped

To open and close the hood

Lights

Windshield wipers and washers

Tilt/telescoping steering column

Power tilt/telescoping steering column - if equipped

Heated steering wheel - if equipped

Electronic speed control - if equipped

Adaptive cruise control (acc) - if equipped

Forward collision warning (fcw) with mitigation - if equipped

Parksense rear park assist - if equipped

Parkview rear back up camera - if equipped

Overhead console

Garage door opener - if equipped

Power sunroof - if equipped

Electrical power outlets

Power inverter - if equipped

Cupholders

Storage

Cargo area features

Rear window features

Roof luggage rack - if equipped

Dodge Durango Owners Manual / Understanding the features of your vehicle / Parksense rear park assist - if equipped

Dodge Durango Owners Manual

Categories


© 2017-2024 Copyright www.dodurango.net
0.0165