REMOVAL
(1) Remove overdrive unit from the vehicle.
(2) Remove overdrive geartrain from housing.
(3) Remove snap ring holding output shaft rear bearing into overdrive housing (Fig. 97).
(4) Using a suitable driver inserted through the rear end of housing, drive bearing from housing.
INSTALLATION
(1) Place replacement bearing in position in housing.
(2) Using a suitable driver, drive bearing into housing until the snap ring groove is visible.
(3) Install snap ring to hold bearing into housing (Fig. 97).
(4) Install overdrive geartrain into housing.
(5) Install overdrive unit in vehicle.
Fig. 97 Output Shaft Rear Bearing
1 - OUTPUT SHAFT REAR BEARING
2 - OVERDRIVE HOUSING
3 - SNAP RING