Dodge Durango Service ManualVehicle Theft/Security Systems » Removal and installation
Liftgate lock cylinder switch
Liftgate lock cylinder switch
(1) Disconnect and isolate the battery negative cable.
(2) Remove the trim panel from the liftgate inner panel. Refer to Group 23 - Body for the procedures.
Fig. 2 Door Lock Cylinder Switch Remove/Install - Typical
1 - DOOR OUTSIDE LATCH HANDLE
2 - DOOR
3 - DOOR LOCK CYLINDER SWITCH
4 - CONNECTOR
5 - RETAINERS
(3) Reach through the access hole in the liftgate inner panel to disengage the switch from the back of the liftgate lock cylinder (Fig. 3).
Fig. 3 Liftgate Lock Cylinder Switch Remove/Install
1 - LIFTGATE INNER PANEL
2 - LIFTGATE LATCH OUTSIDE HANDLE
3 - LIFTGATE LOCK CYLINDER SWITCH
4 - WIRE HARNESS CONNECTOR
(4) Unplug the liftgate lock cylinder switch wire harness connector.
(5) Remove the liftgate lock cylinder switch from the liftgate.
(6) Reverse the removal procedures to install.
Door ajar switch
Door lock cylinder switch
Liftgate lock cylinder switch
Headlamp relay
Horn relay
Dodge Durango Service Manual
- Lubrication and Maintenance
- Suspension
- Differential and Driveline
- Brakes
- Cooling System
- Battery
- Starting Systems
- Charging System
- Ignition System
- Instrument Panel Systems
- Audio Systems
- Horn Systems
- Speed Control System
- Turn Signal and Hazard Warning Systems
- Wiper and Washer Systems
- Lamps
- Passive Restraint Systems
- Electrically Heated Systems
- Power Distribution System
- Power Lock Systems
- Vehicle Theft/Security Systems
- Power Seat System
- Power Window Systems
- Power Mirror Systems
- Chime/Buzzer Warning Systems
- Overhead Console Systems
- Engine
- Exhaust System
- Frame and Bumpers
- Fuel System
- Steering
- Transmission and Transfer Case
- Tires and Wheels
- Body
- Heating and Air Conditioning
- Emission Control Systems
- Introduction
Categories
0.007