REMOVAL
1) Raise and support vehicle.
(2) Remove wheel and tire assembly.
(3) Remove brake caliper, rotor, and ABS wheel speed sensor if equipped, refer to Group 5 Brakes.
(4) Remove hub/bearing spindle nut and discard nut (Fig. 10).
CAUTION: The hub/bearing spindle nut can not be re-used.
(5) Slide hub/bearing off spindle.
INSTALLATION
(1) Slide hub/bearing on spindle.
Fig. 10 Hub/Bearing
1 - KNUCKLE
2 - HUB/BEARING
3 - SPINDLE NUT
(2) Install new spindle nut and tighten to 251 N*m (185 ft. lbs.).
(3) Install brake rotor, caliper, and ABS wheel speed sensor if equipped, refer to Group 5 Brakes.
(4) Install wheel and tire assembly.
(5) Remove support and lower vehicle.