Front door trim panel. Front door waterdam

Front door trim panel

REMOVAL

(1) Release door latch and open door.

(2) Roll window down.

(3) Remove window crank (Fig. 23), if equipped.

(4) Remove screws attaching trim panel to door (Fig. 24) and (Fig. 25).

CAUTION: Do not forcibly pull trim panel from door, damage to trim panel may occur.

(5) Simultaneously lift upward and outward to release retainer steps from inner door panel (Fig. 26).

(6) Disengage inside handle linkage rod from inside handle.

(7) Disconnect speaker harness wire connector (Fig. 27).

(8) Disengage power mirror wire connector, if equipped (driver's side only) (Fig. 27).

(9) Disengage clips attaching power window/lock switch panel to door trim panel. Disengage wire connector from switch panel, if equipped (Fig. 28).

(10) Separate door trim panel from vehicle.

INSTALLATION

(1) Position trim panel at door.

(2) Engage wire connector for window/lock switch panel, if equipped.

(3) Engage power mirror wire connector, if equipped.

Fig. 23 Window Crank-Typical

1 - WINDOW CRANK REMOVAL TOOL

2 - WINDOW CRANK

Fig. 24 Door Trim Panel

1 - TRIM PANEL

(4) Connect speaker harness wire connector.

(5) Engage inside handle linkage rod to inside handle.

(6) Align trim panel retainer steps with inner door panel and slide trim panel into place.

(7) Install screws attaching trim panel to door.

(8) Install window crank, if equipped.

Front door waterdam

REMOVAL

(1) Remove the trim panel from the door.

(2) Carefully separate the waterdam from the door inner panel at the areas with adhesive (Fig. 29).

Remove the waterdam from the door inner panel.

Fig. 25 Trim Panel Screw

1 - INNER DOOR PANEL

2 - INSIDE DOOR HANDLE BRACKET

3 - TRIM PANEL

4 - INSIDE DOOR HANDLE

Fig. 26 Trim Panel Retainer

1 - TRIM PANEL

2 - RETAINER STEP

3 - INNER DOOR PANEL

INSTALLATION

(1) Apply an appropriate adhesive/sealant to the waterdam edges before installing it.

(2) Position the waterdam on the door inner panel and press it inward at the areas with the adhesive to attach it to the inner panel.

(3) Ensure that the retainer step pockets are position correctly in the door inner panel.

(4) Install the door trim panel.

Fig. 27 Speaker And Power Mirror Connector

1 - POWER MIRROR CONNECTOR

2 - TRIM PANEL

3 - SPEAKER CONNECTOR

Fig. 28 Power Door Lock/Window Connector

1 - POWER MIRROR SWITCH

2 - TWEETER

3 - POWER WINDOW SWITCH

4 - WIRE HARNESS CONNECTOR