Dodge Durango

 Service Manual

Instrument Panel Systems » Diagnosis and testing » Instrument cluster
Four-wheel drive lock indicator lamp

The diagnosis found here addresses an inoperative four-wheel drive indicator lamp condition. If the problem being diagnosed is related to lamp accuracy, be certain to confirm that the problem is with the lamp or switch and not with a damaged or inoperative transfer case or transfer case linkage. Refer to NV231 Diagnosis or NV242 Diagnosis in the Diagnosis and Testing section of Group 21 - Transmission for more information. If no transfer case problem is found, the following procedure will help locate a short or open in the indicator lamp circuit. For complete circuit diagrams, refer to Instrument Cluster in the Contents of Group 8W - Wiring Diagrams.

(1) Check the fused ignition switch output (run/ start) fuse in the junction block. If OK, go to Step 2.

If not OK, repair the shorted circuit or component as required and replace the faulty fuse.

(2) Turn the ignition switch to the On position.

Check for battery voltage at the fused ignition switch output (run/start) fuse in the junction block. If OK, go to Step 3. If not OK, repair the open fused ignition switch output (run/start) circuit to the ignition switch as required.

(3) Turn the ignition switch to the Off position.

Disconnect and isolate the battery negative cable.

Disconnect the transfer case switch wire harness connector.

Check for continuity between the ground circuit cavity of the transfer case switch wire harness connector and a good ground. There should be continuity.

If OK, go to Step 4. If not OK, repair the open ground circuit to ground as required.

(4) Connect the battery negative cable. Turn the ignition switch to the On position. Install a jumper wire between the four wheel drive lock indicator lamp driver circuit cavity of the transfer case switch wire harness connector and a good ground. The four- wheel drive lock indicator lamp should light. If OK, replace the faulty transfer case switch. If not OK, go to Step 5.

(5) Turn the ignition switch to the Off position.

Disconnect and isolate the battery negative cable.

Disconnect the wire harness connector at the Controller Anti-Lock Brake (CAB). Remove the instrument cluster. With the transfer case switch wire harness connector still disconnected, check for continuity between the four wheel drive lock indicator lamp driver circuit cavity of the instrument cluster wire harness connector B and a good ground. There should be no continuity. If OK, go to Step 6. If not OK, repair the shorted four wheel drive lock indicator lamp driver circuit as required.

(6) Check for continuity between the four wheel drive lock indicator lamp driver circuit cavities of the instrument cluster wire harness connector B and the transfer case switch wire harness connector. There should be continuity. If OK, replace the faulty bulb.

If not OK, repair the open four wheel drive lock indicator lamp driver circuit as required.

Preliminary diagnosis

Self-diagnostic test

Brake warning lamp

Cluster illumination lamp

Four-wheel drive lock indicator lamp

Headlamp high beam indicator lamp

Low washer fluid warning lamp

Security lamp

Turn signal indicator lamp