Toyota
Dodge Durango
 Service Manual
Engine » Removal and installation
Engine oil pressure sending unit

Fig. 122 Oil Pan Tightening Sequence Fig. 122 Oil Pan Tightening Sequence

REMOVAL

(1) Disconnect the negative cable from the battery.

(2) Raise vehicle on hoist.

(3) Remove front splash shield.

(4) Disconnect oil pressure sender wire (Fig. 125).

(5) Remove the pressure sender (Fig. 125).

INSTALLATION

(1) Install oil pressure sender.

(2) Connect oil pressure sender wire.

(3) Install front splash shield.

(4) Lower vehicle.

(5) Connect the negative battery cable.

Fig. 123 Flexplate Tightening Sequence Fig. 123 Flexplate Tightening Sequence

1 - FLEXPLATE

    More about «Removal and installation»:

    Engine mounts-left and right

    Engine mount-rear

    Structural cover

    Engine assembly

    Intake manifold

    Exhaust manifolds

    Cylinder head cover

    Rocker arms

    Cylinder heads

    Valve springs and seals

    Hydraulic lash adjuster

    Crankshaft damper

    Timing chain cover

    Timing chain and sprockets

    Idler shaft-timing drive

    Camshafts-in vehicle

    Crankshaft main bearings

    Oil pan 4x2 vehicle

    Oil pan 4x4 vehicle

    Piston and connecting rod

    Crankshaft

    Flexplate

    Oil pump

    Engine oil pressure sending unit

    Crankshaft oil seal-front

    Crankshaft oil seal-rear

    Engine core plugs

    Dodge Durango Service Manual / Engine / Removal and installation / Engine oil pressure sending unit

    Dodge Durango Service Manual

    Categories


    © 2017-2024 Copyright www.dodurango.net
    0.0222