REMOVAL
(1) Disconnect the negative cable from the battery.
CAUTION: Remove the fan blade, fan clutch and fan shroud before raising engine. Failure to do so may cause damage to the fan blade, fan clutch and fan shroud.
(2) Remove the fan blade, fan clutch and fan shroud. Refer to Group 7. for procedure.
(3) Remove the engine oil filter.
(4) Support the engine with a suitable jack and a block of wood across the full width of the engine oil pan.
(5) Remove the four (4) cylinder block-to-insulator mount bolts and the nut from the engine insulator mount through bolt (4x2 Vehicles only) (Fig. 32) (Fig.
33).
(6) Remove the three (3) cylinder block-to-insulator mount bolts and loosen the nut from the engine insulator mount through bolt (4x4 Vehicles only) (Fig. 34) (Fig. 35).
(7) Using the jack, raise the engine high enough to remove the engine insulator mount through bolt and the insulator mount.
Fig. 32 Engine Insulator Mount 4x2 Vehicle-Left Side
1 - ENGINE INSULATOR MOUNT-LEFT SIDE
2 - MOUNTING BOLT
Fig. 33 Engine Insulator Mount 4x2 Vehicle-Right Side
1 - ENGINE INSULATOR MOUNT-RIGHT SIDE
2 - MOUNTING BOLT
INSTALLATION
(1) Position the insulator mount and install the insulator mount through bolt.
(2) Lower the engine until the four cylinder blockto- insulator mount bolts can be installed.
(3) Remove the jack and block of wood.
(4) Torque the cylinder block-to-insulator mount bolts to 61N*m ( 45 ft. lbs.).
(5) Install and torque the through bolt retaining nut to 61N*m (45 ft. lbs.).
(6) Install the fan blade, fan clutch and fan shroud.
Fig. 34 Engine Insulator Mount 4x4 Vehicle-Left Side
1 - ENGINE INSULATOR MOUNT-LEFT SIDE
2 - MOUNTING BOLT
Fig. 35 Engine Insulator Mount 4x4 Vehicle-Right Side
1 - ENGINE INSULATOR MOUNT-RIGHT SIDE
2 - MOUNTING BOLT