Dodge Durango

 Owners Manual

Understanding your instrument panel » Driver information display (DID)
DID Displays

The DID displays are located in the center portion of the cluster and consist of multiple sections:

•  Main Screen - The inner ring of the display will illuminate in grey under normal conditions, yellow for non critical warnings, red for critical warnings, and white for on demand information.
•  Sub-menu Dots- Whenever there are submenus available, the position within the submenus is shown here.
•  Reconfigurable Telltales/Information
•  Gear Selector Status (PRNDL)
•  Selectable Information (Compass, Temp, Range to Empty, Trip A, Trip B, Average Fuel Economy, Current Fuel Economy)
•  AWD Status - If Equipped

The main display area will normally display the main menu or the screens of a selected feature of the main menu. The main display area also displays "pop up" messages that consist of approximately 60 possible warning or information messages. These pop up messages fall into several categories:

•  Five Second Stored Messages

When the appropriate conditions occur, this type of message takes control of the main display area for five seconds and then returns to the previous screen. Most of the messages of this type are then stored (as long as the condition that activated it remains active) and can be reviewed from the "Messages" main menu item. Examples of this message type are "Right Front Turn Signal Lamp Out" and "Low Tire Pressure."

•  Unstored Messages

This message type is displayed indefinitely or until the condition that activated the message is cleared. Examples of this message type are "Turn Signal On" (if a turn signal is left on) and "Lights On" (if driver leaves the vehicle).

•  Unstored Messages Until RUN

These messages deal primarily with the Remote Start feature. This message type is displayed until the ignition is in the RUN state. Examples of this message type are "Remote Start Aborted - Door Ajar" and "Press Brake Pedal and Push Button to Start."

•  Five Second Unstored Messages

When the appropriate conditions occur, this type of message takes control of the main display area for five seconds and then returns to the previous screen. An example of this message type is "Automatic High Beams On."

DID Displays

Engine Oil Life Reset

DID Messages

DID Selectable Menu Items

Screen Setup Driver Selectable Items

Battery Saver On/Battery Saver Mode Message - Electrical Load Reduction Actions - If Equipped