Toyota
Dodge Durango
 Service Manual
Ignition System » Removal and installation
Crankshaft position sensor-4.7L v-8 engine

REMOVAL

The Crankshaft Position (CKP) sensor is located at the right-rear side of the engine cylinder block (Fig.

28). It is positioned and bolted into a machined hole in the engine block.

(1) Disconnect CKP electrical connector at sensor.

(2) Remove CKP mounting bolt (Fig. 28).

(3) Carefully pry sensor from cylinder block in a rocking action with two small screwdrivers.

(4) Remove sensor from vehicle.

(5) Check condition of sensor o-ring.

INSTALLATION

(1) Clean out machined hole in engine block.

(2) Apply a small amount of engine oil to sensor o-ring.

(3) Install sensor into engine block with a slight rocking action. Do not twist sensor into position as damage to o-ring may result.

CAUTION: Before tightening sensor mounting bolt, be sure sensor is completely flush to cylinder block. If sensor is not flush, damage to sensor mounting tang may result.

Fig. 28 CKP Sensor Location/Removal/Installation- 4.7L V-8 Engine Fig. 28 CKP Sensor Location/Removal/Installation- 4.7L V-8 Engine

1 - CRANKSHAFT POSITION SENSOR

2 - MOUNTING BOLT

(4) Install mounting bolt and tighten to 28 N*m (21 ft. lbs.) torque.

(5) Connect electrical connector to sensor.

    More about «Removal and installation»:

    Spark plug cables

    Spark plugs

    Ignition coil-3.9/5.2/5.9L engines

    Ignition coil-4.7L engine

    Crankshaft position sensor-3.9/5.2/ 5.9L engines

    Crankshaft position sensor-4.7L v-8 engine

    Camshaft position sensor

    Camshaft position sensor-4.7L engine

    Distributors-3.9/5.2/5.9L engines

    Ignition switch and key cylinder

    Column shift interlock

    Dodge Durango Service Manual / Ignition System / Removal and installation / Crankshaft position sensor-4.7L v-8 engine

    Dodge Durango Service Manual

    Categories


    © 2017-2024 Copyright www.dodurango.net
    0.0086