Toyota
Dodge Durango
 Service Manual
Brakes » Base brake system » Removal and installation
Combination valve

REMOVAL

(1) Disconnect wire from the pressure differential switch.

(2) Disconnect rear brake lines from combination valve.

(3) Remove the bolt from the combination valve and remove the valve.

INSTALLATION

(1) Install the combination valve to the bracket and tighten the mounting bolt to 20-27 N*m (15-20 ft.

lbs.). If vehicle is equipped with ABS brakes tighten the bolt to 10-13 N*m (7-10 ft. lbs.).

(2) Install the brake lines to the combination valve.

(3) Tighten the brake line to 19 N*m (170 in. lbs.).

(4) Connect the wire to the pressure differential switch.

(5) Bleed brakes system.

    More about «Removal and installation»:

    Brake lamp switch

    Brake pedal

    Combination valve

    Master cylinder

    Power brake booster

    Disc brake caliper

    Disc brake shoes

    Disc brake rotor

    Rear brake shoes

    Wheel cylinder

    Brake support plate

    Front park brake cable

    Rear park brake cables

    Park brake pedal assembly

    Dodge Durango Service Manual / Brakes / Base brake system / Removal and installation / Combination valve

    Dodge Durango Service Manual

    Categories


    © 2017-2024 Copyright www.dodurango.net
    0.0193