WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, REFER TO GROUP 8M - PASSIVE RESTRAINT SYSTEMS BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.
REMOVAL
(1) Disconnect and isolate the battery negative cable.
(2) Remove the steering column opening cover from the instrument panel. Refer to Steering Column Opening Cover in the Removal and Installation section of Group 8E - Instrument Panel Systems for the procedures.
(3) Reach through the outboard side of the steering column opening in the instrument panel to access the relay and fuse block on the back of the junction block (Fig. 4).
(4) Refer to Fuse/Fuse Block in the Contents of Group 8W - Wiring Diagrams for combination flasher identification and location.
(5) Remove the combination flasher from the relay and fuse block.
INSTALLATION
(1) Refer to Fuse/Fuse Block in the Contents of Group 8W - Wiring Diagrams for proper combination flasher location.
(2) Position the combination flasher in the proper receptacle in the relay and fuse block.
(3) Align the combination flasher terminals with the terminal cavities in the relay and fuse block receptacle.
(4) Push in firmly on the combination flasher until the terminals are fully seated in the terminal cavities in the relay and fuse block receptacle.
(5) Install the steering column opening cover onto the instrument panel. Refer to Steering Column Opening Cover in the Removal and Installation section of Group 8E - Instrument Panel Systems for the procedures.
(6) Reconnect the battery negative cable.
Fig. 3 Multi-Function Switch Continuity
Fig. 4 Combination Flasher Remove/Install
1 - ELECTRONIC COMBINATION FLASHER
2 - RELAY AND FUSE BLOCK