NOTE: CLOTH TRIM IS BONDED TO THE CUSHION FOAM
REMOVAL
(1) Remove the anchor bolt attaching the seat belt to the seat track (Fig. 3).
(2) Remove seat.
(3) Remove the screw attaching the recliner handle to the recliner mechanism.
(4) Remove seat side shield and disconnect wire harness.
(5) Disengage the rearward J-straps.
(6) Disengage both side J-straps.
(7) Disengage the front J-strap.
(8) Disengage hook and loop fasteners.
(9) Separate the cushion/cover from the frame.
INSTALLATION
(1) Install anti-squeak sheet.
(2) Position the cushion/cover on the frame.
(3) Engage the front J-strap.
(4) Engage the side J-straps.
(5) Engage the rearward corner J-straps.
(6) Engage hook and loop fasteners.
(7) Engage the rear J-strap.
(8) Install the recliner handle.
(9) Install seat. Tighten the front seat track bolts to 22-34 N*m (16-25 ft. lbs.). Tighten the rear seat track bolts to 89-140 N*m (66-103 ft lbs.).
Fig. 3 Buckle Anchor Bolt
1 - ANCHOR BOLT
2 - SEAT TRACK
3 - SEAT CUSHION
4 - BUCKLE
(10) Install the anchor bolt attaching the belt to the seat track. Tighten the bolt to 40 N*m (29 ft.
lbs.).
Bucket seat recliner
The bucket seat recliner is included with the seat assembly. If service is needed, replace the seat assembly.