Brake lamp switch. Brake pedal

Brake lamp switch

REMOVAL

(1) Disconnect switch harness (Fig. 15).

(2) Press and hold brake pedal in applied position.

(3) Rotate switch counterclockwise about 30 to align switch lock tab with notch in bracket.

(4) Pull switch rearward out of mounting bracket and release brake pedal.

INSTALLATION

(1) Press and hold brake pedal down.

Fig. 15 Brake Lamp Switch & Bracket

1 - RELEASE LEVER

2 - BRACKET

3 - BRAKE PEDAL SUPPORT

4 - BRAKE LAMP SWITCH

2) Align tab on new switch with notch in switch bracket. Then insert switch in bracket and turn it clockwise about 30 to lock it in place.

(3) Connect harness wires to switch.

(4) Release brake pedal.

(5) Move the release lever (Fig. 15) on the switch to engage the switch plunger. The switch is now adjusted and can not be adjusted again.

REMOVAL

(1) Remove stop lamp switch.

(2) Remove clip securing booster push rod to brake pedal (Fig. 16).

(3) Remove pedal pivot pin C-clip and slide pin out of support bracket and pedal.

(4) Remove pedal and bushings.

INSTALLATION

(1) Replace bushings if worn or damaged.

(2) Lubricate pedal bushings and pivot pin with Mopar multi mileage grease, Lubriplate, or a silicone grease.

(3) Install bushings in pedal and position pedal in support.

(4) Insert pivot pin through support and pedal bushings and install C-clip.

Fig. 16 Brake Pedal Mounting

1 - PIVOT PIN

2 - CLIP

3 - BUSHINGS

4 - BRAKE PEDAL

5 - BUSHINGS

6 - CLIP

(5) Install booster push rod on brake pedal and install push rod retainer clip.

(6) Install stop lamp switch.