Dodge Durango

 Service Manual

Fuel System » Fuel injection system » Removal and installation
Automatic shutdown (asd) relay

The ASD relay is located in the Power Distribution Center (PDC) (Fig. 17). Refer to label on PDC cover for relay location.

Fig. 17 Power Distribution Center (PDC) Location

1 - POWER DISTRIBUTION CENTER (PDC)

REMOVAL

(1) Remove PDC cover.

(2) Remove relay from PDC.

(3) Check condition of relay terminals and PDC connector terminals for damage or corrosion. Repair if necessary before installing relay.

(4) Check for pin height (pin height should be the same for all terminals within the PDC connector).

Repair if necessary before installing relay.

INSTALLATION

(1) Install relay to PDC.

(2) Install cover to PDC.

Automatic shutdown (asd) relay

Fuel pump relay

Oxygen sensor heater relays

Throttle body-3.9/5.2/5.9L engines

Throttle body-4.7L v-8 engine

Throttle position sensor (tps)-3.9/ 5.2/5.9L engines

Throttle position sensor (tps)-4.7L v-8 engine

Idle air control (iac) motor-3.9/5.2/ 5.9L engines

Idle air control (iac) motor-4.7L v-8 engine

Manifold absolute pressure (map) sensor-3.9/5.2/5.9L engines

Manifold absolute pressure (map) sensor-4.7L v-8 engine

Powertrain control module (pcm)

Oxygen sensor

Air cleaner element (filter)

Engine coolant temperature sensor-3.9/5.2/5.9L engines

Engine coolant temperature sensor-4.7L v-8 engine

Intake manifold air temperature sensor-3.9/5.2/5.9L engines

Intake manifold air temperature sensor-4.7L v-8 engine

Power steering pressure switch