Toyota
Dodge Durango
 Service Manual
Differential and Driveline » 8 1/4 And 9 1/4 axle » Diagnosis and testing
Trac-loky test

WARNING: WHEN SERVICING VEHICLES WITH A TRAC-LOKY DIFFERENTIAL DO NOT USE THE ENGINE TO TURN THE AXLE AND WHEELS. BOTH REAR WHEELS MUST BE RAISED AND THE VEHICLE SUPPORTED. A TRAC-LOKY AXLE CAN EXERT ENOUGH FORCE IF ONE WHEEL IS IN CONTACT WITH A SURFACE TO CAUSE THE VEHICLE TO MOVE.

The differential can be tested without removing the differential case by measuring rotating torque. Make sure brakes are not dragging during this measurement.

(1) Place blocks in front and rear of both front wheels.

(2) Raise one rear wheel until it is completely off the ground.

(3) Engine off, transmission in neutral, and parking brake off.

(4) Remove wheel and bolt Special Tool 6790 to studs.

(5) Use torque wrench on special tool to rotate wheel and read rotating torque (Fig. 8).

Fig. 8 Trac-lokY Test -Typical Fig. 8 Trac-lokY Test -Typical

1 - SPECIAL TOOL 6790 WITH BOLT IN CENTER HOLE

2 - TORQUE WRENCH

(6) If rotating torque is less than 22 N*m (30 ft.

lbs.) or more than 271 N*m (200 ft. lbs.) on either wheel the unit should be serviced.

    More about «Diagnosis and testing»:

    General information

    Gear noise

    Bearing noise

    Vibration

    Driveline snap

    Trac-loky differential noise

    Trac-loky test

    Dodge Durango Service Manual / Differential and Driveline / 8 1/4 And 9 1/4 axle / Diagnosis and testing / Trac-loky test

    Dodge Durango Service Manual

    Categories


    © 2017-2024 Copyright www.dodurango.net
    0.0071