Toyota
Dodge Durango
 Service Manual
Suspension » Front suspension - 4x2 » Removal and installation
Stabilizer bar

REMOVAL

(1) Raise and support the vehicle.

(2) Remove the upper link nut, retainer and grommet from each link.

(3) Remove the lower link nut from the lower suspension arm on each side (Fig. 9).

(4) Remove the stabilizer bar retainer bolts and remove the retainers and stabilizer bar from the vehicle.

(5) Remove the bushings from the stabilizer bar.

INSTALLATION

(1) Install the bushings on the stabilizer bar.

(2) Install the stabilizer bar on the frame and install the retainers and the bolts.

(3) Tighten the bolts to 60 N*m (45 ft. lbs.).

Fig. 9 Stabilizer Bar Fig. 9 Stabilizer Bar

1 - RETAINER

2 - GROMMET

3 - STABILIZER LINK

4 - STABILIZER BAR

NOTE: Ensure the bar is center with equal spacing on both sides.

(4) Install the link lower retainer and grommet on the links.

(5) Install the links into the stabilizer bar and lower suspension arm on each side.

(6) Install the lower link mounting nut and tighten to 47 N*m (35 ft. lbs.).

NOTE: Ensure both link end caps are facing straight forward.

(7) Install the upper link grommet, retainer and nut and tighten to 37 N*m (27 ft. lbs.).

(8) Remove support and lower vehicle.

    More about «Removal and installation»:

    Shock absorber

    Coil spring

    Steering knuckle

    Lower suspension arm

    Upper suspension arm

    Stabilizer bar

    Hub/bearing

    Wheel mounting studs

    Dodge Durango Service Manual / Suspension / Front suspension - 4x2 / Removal and installation / Stabilizer bar

    Dodge Durango Service Manual

    Categories


    © 2017-2024 Copyright www.dodurango.net
    0.0219