Dodge Durango Service ManualSuspension » Rear suspension » Removal and installation
Shock absorber
Dodge Durango
Service Manual
Shock absorber
REMOVAL
(1) Raise vehicle and support rear axle.
(2) Remove shock absorber lower nut and bolt from the spring plate (Fig. 2).
(3) Remove shock absorber upper nut and bolt from the frame bracket and remove the shock absorber.
INSTALLATION
(1) Install shock absorber into upper frame bracket. Install bolt and nut and tighten nut to 95 N*m (70 ft. lbs.).
(2) Install shock absorber into the spring plate.
Install the bolt and nut and tighten nut to 95 N*m (70 ft. lbs.).
(3) Remove axle support and lower vehicle.
Fig. 2 Shock Absorber
More about «Removal and installation»:
Shock absorber
Stabilizer bar
Leaf springs
Dodge Durango Service Manual / Suspension / Rear suspension / Removal and installation / Shock absorber
Dodge Durango Service Manual
- Lubrication and Maintenance
- Suspension
- Differential and Driveline
- Brakes
- Cooling System
- Battery
- Starting Systems
- Charging System
- Ignition System
- Instrument Panel Systems
- Audio Systems
- Horn Systems
- Speed Control System
- Turn Signal and Hazard Warning Systems
- Wiper and Washer Systems
- Lamps
- Passive Restraint Systems
- Electrically Heated Systems
- Power Distribution System
- Power Lock Systems
- Vehicle Theft/Security Systems
- Power Seat System
- Power Window Systems
- Power Mirror Systems
- Chime/Buzzer Warning Systems
- Overhead Console Systems
- Engine
- Exhaust System
- Frame and Bumpers
- Fuel System
- Steering
- Transmission and Transfer Case
- Tires and Wheels
- Body
- Heating and Air Conditioning
- Emission Control Systems
- Introduction
Categories
© 2017-2023 Copyright www.dodurango.net
0.049
0.049