Toyota
Dodge Durango
 Service Manual
Suspension » Front suspension - 4x2 » Removal and installation
Shock absorber

REMOVAL

1) Remove the upper shock nut, retainer and grommet from the shock absorber stud (Fig. 3).

(2) Raise and support the vehicle.

(3) Remove the lower mounting bolts and remove shock absorber through the lower suspension arm (Fig. 3).

INSTALLATION

NOTE: Upper shock nut must be replaced or use Mopar Lock 'N Seal or LoctiteT 242 on existing nut.

Fig. 3 Front Shock Absorber Fig. 3 Front Shock Absorber

1 - RETAINER

2 - GROMMET

3 - SHOCK ABSORBER

(1) Install the lower retainer (lower retainer is stamped with a L) and grommet on the shock absorber stud and extend the shock. Insert the shock absorber through the lower suspension arm and upper mounting hole.

(2) Install the lower mounting bolts and tighten to 28 N*m (21 ft. lbs.).

(3) Remove support and lower the vehicle.

(4) Install the upper grommet and retainer (upper retainer is stamped with a U) on the shock absorber stud. Install a new nut or use Mopar Lock 'N Seal or Loctitet 242 on existing nut and tighten to 26 N*m (19 ft. lbs.).

    More about «Removal and installation»:

    Shock absorber

    Coil spring

    Steering knuckle

    Lower suspension arm

    Upper suspension arm

    Stabilizer bar

    Hub/bearing

    Wheel mounting studs

    Dodge Durango Service Manual / Suspension / Front suspension - 4x2 / Removal and installation / Shock absorber

    Dodge Durango Service Manual

    Categories


    © 2017-2023 Copyright www.dodurango.net
    0.0153