
Dodge Durango
Owners Manual
Understanding the features of your vehicle » Garage door opener - if equipped
Programming A Rolling Code
For programming garage door openers that were manufactured
after 1995:
These garage door openers can be identified by the
"LEARN" or "TRAIN" button located where the hanging
antenna is attached to the garage door opener. It is NOT
the button that is normally used to open and close the
door. The name and color of the button may vary by
manufacturer.
Training The Garage Door Opener
1 - Door Opener
2 - Training Button
- Place the ignition in the ON/RUN position.
- Place the hand-held transmitter 1 to 3 inches
(3 to 8 cm) away from the HomeLink button you wish
to program while keeping the HomeLink indicator
light in view.
- Push and hold the HomeLink button you want to
program while you push and hold the hand-held
transmitter button.
- Continue to hold both buttons and observe the indicator
light. The HomeLink indicator will flash slowly
and then rapidly after HomeLink has received the
frequency signal from the hand-held transmitter. Release
both buttons after the indicator light changes
from slow to rapid.
- At the garage door opener motor (in the garage),
locate the "LEARN" or "TRAINING" button. This can
usually be found where the hanging antenna wire is
attached to the garage door opener/device motor.Firmly push and release the "LEARN" or "TRAINING"
button. On some garage door openers/devices
there may be a light that blinks when the garage door
opener/device is in the LEARN/TRAIN mode.NOTE: You have 30 seconds in which to initiate the next
step after the LEARN button has been pushed.
- Return to the vehicle and push the programmed
HomeLink button twice (holding the button for two
seconds each time). If the garage door opener/device
activates, programming is complete.
NOTE: If the garage door opener/device does not activate,
push the button a third time (for two seconds) to
complete the training.
To program the remaining two HomeLink buttons, repeat
each step for each remaining button. DO NOT erase the
channels.
Reprogramming A Single HomeLink Button
(Rolling Code)
To reprogram a channel that has been previously trained,
follow these steps:
- Cycle the ignition to the ON/RUN position.
- Push and hold the desired HomeLink button until the
indicator light begins to flash after 20 seconds. Do not
release the button.
- Without releasing the button, proceed with "Programming
A Rolling Code" step 2 and follow all
remaining steps.
More about «Garage door opener - if equipped»:
Programming A Rolling Code