REMOVAL
(1) Remove brake lines from the master cylinder (Fig. 17).
(2) Remove mounting nuts from the master cylinder (Fig. 17).
(3) Remove master cylinder.
Fig. 17 Master Cylinder
1 - MOUNTING NUT
2 - MOUNTING NUT
3 - BRAKE LINES
4 - MASTER CYLINDER
INSTALLATION
NOTE: If master cylinder is replaced bleed cylinder before installation.
(1) Install master cylinder on booster mounting studs.
(2) Install mounting nuts and tighten to 18 N*m (160 in. lbs.) (3) Install brake lines and tighten to 19 N*m (170 in. lbs.) (4) Fill and bleed base brake system.