Dodge Durango

 Service Manual

Engine » Removal and installation
Hydraulic lash adjuster

REMOVAL

(1) Remove cylinder head cover(s). Refer to procedure in this section.

(2) Remove rocker arm(s). Refer to procedure in this section.

CAUTION: If lash adjusters and rocker arms are to be reused, always mark position for reassembly in their original positions.

(3) Remove lash adjuster(s).

Fig. 68 Valve Assembly Configuration

1 - VALVE LOCKS (3-BEAD)

2 - RETAINER

3 - VALVE STEM OIL SEAL

4 - INTAKE VALVE

5 - EXHAUST VALVE

6 - VALVE SPRING

INSTALLATION

(1) Install hydraulic lash adjuster making sure adjusters are at least partially full of oil. This can be verified by little or no plunger travel when lash adjuster is depressed.

(2) Install rocker arm(s). Refer to procedure in this section.

(3) Install cylinder head cover(s). Refer to procedure in this section.

Engine mounts-left and right

Engine mount-rear

Structural cover

Engine assembly

Intake manifold

Exhaust manifolds

Cylinder head cover

Rocker arms

Cylinder heads

Valve springs and seals

Hydraulic lash adjuster

Crankshaft damper

Timing chain cover

Timing chain and sprockets

Idler shaft-timing drive

Camshafts-in vehicle

Crankshaft main bearings

Oil pan 4x2 vehicle

Oil pan 4x4 vehicle

Piston and connecting rod

Crankshaft

Flexplate

Oil pump

Engine oil pressure sending unit

Crankshaft oil seal-front

Crankshaft oil seal-rear

Engine core plugs