Dodge Durango
Service Manual
Suspension » Front suspension - 4x2 » Removal and installation
Hub/bearing

REMOVAL

1) Raise and support vehicle.

(2) Remove wheel and tire assembly.

(3) Remove brake caliper, rotor, and ABS wheel speed sensor if equipped, refer to Group 5 Brakes.

(4) Remove hub/bearing spindle nut and discard nut (Fig. 10).

CAUTION: The hub/bearing spindle nut can not be re-used.

(5) Slide hub/bearing off spindle.

INSTALLATION

(1) Slide hub/bearing on spindle.

Fig. 10 Hub/Bearing

1 - KNUCKLE

2 - HUB/BEARING

3 - SPINDLE NUT

(2) Install new spindle nut and tighten to 251 N*m (185 ft. lbs.).

(3) Install brake rotor, caliper, and ABS wheel speed sensor if equipped, refer to Group 5 Brakes.

(4) Install wheel and tire assembly.

(5) Remove support and lower vehicle.

More about «Removal and installation»:

Shock absorber