Toyota
Dodge Durango
 Service Manual
Vehicle Theft/Security Systems » Removal and installation
Headlamp relay

WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, REFER TO GROUP 8M - PASSIVE RESTRAINT SYSTEMS BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.

(1) Disconnect and isolate the battery negative cable.

(2) Remove the cover from the Power Distribution Center (PDC) (Fig. 4).

Fig. 4 Power Distribution Center Fig. 4 Power Distribution Center

1 - CLIP

2 - BATTERY

3 - TRAY

4 - NEGATIVE CABLE

5 - POSITIVE CABLE

6 - CLIP

7 - FENDER INNER SHIELD

8 - POWER DISTRIBUTION CENTER

(3) Refer to the label on the PDC for headlamp relay identification and location.

(4) Unplug the headlamp relay from the PDC.

(5) Install the headlamp relay by aligning the relay terminals with the cavities in the PDC and pushing the relay firmly into place.

(6) Install the PDC cover.

(7) Connect the battery negative cable.

(8) Test the relay operation.

    More about «Removal and installation»:

    Door ajar switch

    Door lock cylinder switch

    Liftgate lock cylinder switch

    Headlamp relay

    Horn relay

    Dodge Durango Service Manual / Vehicle Theft/Security Systems / Removal and installation / Headlamp relay

    Dodge Durango Service Manual

    Categories


    © 2017-2023 Copyright www.dodurango.net
    0.0204