Dodge Durango Service ManualBrakes » Base brake system » Service procedures
Disc rotor machining
Dodge Durango
Service Manual
Disc rotor machining
The disc brake rotor can be machined if scored or worn. The lathe must machine both sides of the rotor simultaneously with dual cutter heads. The rotor mounting surface must be clean before placing on the lathe. Equipment capable of machining only one side at a time may produce a tapered rotor.
NOTE: A hub mounted on-vehicle lathe is recommended.
This type of lathe trues the rotor to the vehicles hub/bearing.
CAUTION: Brake rotors that do not meet minimum thickness specifications before or after machining must be replaced.
More about «Service procedures»:
Brake fluid level
Master cylinder bleeding
Base brake bleeding
Disc rotor machining
Brake drum machining
Brake tube flaring
Dodge Durango Service Manual / Brakes / Base brake system / Service procedures / Disc rotor machining
Dodge Durango Service Manual
- Lubrication and Maintenance
- Suspension
- Differential and Driveline
- Brakes
- Cooling System
- Battery
- Starting Systems
- Charging System
- Ignition System
- Instrument Panel Systems
- Audio Systems
- Horn Systems
- Speed Control System
- Turn Signal and Hazard Warning Systems
- Wiper and Washer Systems
- Lamps
- Passive Restraint Systems
- Electrically Heated Systems
- Power Distribution System
- Power Lock Systems
- Vehicle Theft/Security Systems
- Power Seat System
- Power Window Systems
- Power Mirror Systems
- Chime/Buzzer Warning Systems
- Overhead Console Systems
- Engine
- Exhaust System
- Frame and Bumpers
- Fuel System
- Steering
- Transmission and Transfer Case
- Tires and Wheels
- Body
- Heating and Air Conditioning
- Emission Control Systems
- Introduction
Categories
© 2017-2023 Copyright www.dodurango.net
0.0501
0.0501