Toyota
Dodge Durango
 Service Manual
Engine » Diagnosis and testing
Cylinder combustion pressure leakage test

The combustion pressure leakage test provides an accurate means for determining engine condition.

Combustion pressure leakage testing will detect:

  • Exhaust and intake valve leaks (improper seating).
  • Leaks between adjacent cylinders or into water jacket.
  • Any causes for combustion/compression pressure loss.

(1) Check the coolant level and fill as required. DO NOT install the radiator cap.

(2) Start and operate the engine until it attains normal operating temperature, then turn the engine OFF.

(3) Remove the spark plugs.

(4) Remove the oil filler cap.

(5) Remove the air cleaner.

(6) Calibrate the tester according to the manufacturer's instructions. The shop air source for testing should maintain 483 kPa (70 psi) minimum, 1,379 kPa (200 psi) maximum and 552 kPa (80 psi) recommended.

(7) Perform the test procedures on each cylinder according to the tester manufacturer's instructions.

While testing, listen for pressurized air escaping through the throttle body, tailpipe and oil filler cap opening. Check for bubbles in the radiator coolant.

All gauge pressure indications should be equal, with no more than 25% leakage.

FOR EXAMPLE: At 552 kPa (80 psi) input pressure, a minimum of 414 kPa (60 psi) should be maintained in the cylinder.

Refer to the Cylinder Combustion Pressure Leakage Test Diagnosis chart.

CYLINDER COMBUSTION PRESSURE LEAKAGE DIAGNOSIS CHART

CONDITION POSSIBLE CAUSE CORRECTION
AIR ESCAPES THROUGH THROTTLE BODY Intake valve bent, burnt, or not seated properly Inspect valve and valve seat.

Reface or replace, as necessary

AIR ESCAPES THROUGH TAILPIPE Exhaust valve bent, burnt, or not seated properly Inspect valve and valve seat.

Reface or replace, as necessary

AIR ESCAPES THROUGH RADIATOR Head gasket leaking or cracked cylinder head or block Remove cylinder head and inspect.

Replace defective part

MORE THAN 50% LEAKAGE FROM ADJACENT CYLINDERS Head gasket leaking or crack in cylinder head or block between adjacent cylinders Remove cylinder head and inspect.

Replace gasket, head, or block as necessary

MORE THAN 25% LEAKAGE AND AIR ESCAPES THROUGH OIL FILLER CAP OPENING ONLY Stuck or broken piston rings; cracked piston; worn rings and/or cylinder wall Inspect for broken rings or piston.

Measure ring gap and cylinder diameter, taper and out-of-round.

Replace defective part as necessary

    More about «Diagnosis and testing»:

    Engine diagnosis-introduction

    Service diagnosis-performance

    Service diagnosis-mechanical

    Service diagnosis-lubrication

    Intake manifold leakage diagnosis

    Cylinder compression pressure test

    Cylinder head gasket failure diagnosis

    Cylinder combustion pressure leakage test

    Engine oil leak inspection

    Rear seal area leaks-inspection

    Hydraulic lash adjuster noise diagnosis

    Checking engine oil pressure

    Dodge Durango Service Manual / Engine / Diagnosis and testing / Cylinder combustion pressure leakage test

    Dodge Durango Service Manual

    Categories


    © 2017-2024 Copyright www.dodurango.net
    0.0054