Dodge Durango
 Service Manual
Differential and Driveline » C205F axle
Cleaning and inspection

Axle components

Wash differential components with cleaning solvent and dry with compressed air. Do not steam clean the differential components.

Wash bearings with solvent and towel dry, or dry with compressed air. DO NOT spin bearings with compressed air. Cup and bearing must be replaced as matched sets only.

Clean axle shaft tubes and oil channels in housing.

Inspect for;

  • Smooth appearance with no broken/dented surfaces on the bearing rollers or the roller contact surfaces.
  • Bearing cups must not be distorted or cracked.
  • Machined surfaces should be smooth and without any raised edges.
  • Raised metal on shoulders of cup bores should be removed with a hand stone.
  • Wear and damage to pinion gear mate shaft, pinion gears, side gears and thrust washers. Replace as a matched set only
  • Ring gear and pinion for worn and chipped teeth.
  • Ring gear for damaged bolt threads. Replaced as a matched set only.
  • Companion flange for cracks, worn splines, pitted areas, and a rough/corroded seal contact surface.

    Repair or replace as necessary.

  • Preload shims for damage and distortion. Install new shims, if necessary.
    More about «C205F axle»:

    Description and operation

    Diagnosis and testing

    Service procedures

    Removal and installation

    Disassembly and assembly

    Cleaning and inspection


    Dodge Durango Service Manual / Differential and Driveline / C205F axle / Cleaning and inspection

    Dodge Durango Service Manual


    © 2017-2023 Copyright