
Dodge Durango
Owners Manual
Understanding the features of your vehicle » Garage door opener - if equipped
Canadian/Gate Operator Programming
For programming transmitters in Canada/United States
that require the transmitter signals to "time-out" after
several seconds of transmission:
Canadian radio frequency laws require transmitter signals
to time-out (or quit) after several seconds of transmission,
which may not be long enough for HomeLink to
pick up the signal during programming. Similar to this
Canadian law, some U.S. gate operators are designed to
time-out in the same manner.
It may be helpful to unplug the device during the cycling
process to prevent possible overheating of the garage
door or gate motor.
- Cycle the ignition to the ON/RUN position.
- Place the hand-held transmitter 1 to 3 inches
(3 to 8 cm) away from the HomeLink button you wish
to program while keeping the HomeLink indicator
light in view.
- Continue to push and hold the HomeLink button
while you push and release ("cycle") your hand-held
transmitter every two seconds until HomeLink has
successfully accepted the frequency signal. The indicator
light will flash slowly and then rapidly when
fully trained.
- Watch for the HomeLink indicator to change flash
rates. When it changes, it is programmed. It may take
up to 30 seconds or longer in rare cases. The garage
door may open and close while you are programming.
- Push and hold the programmed HomeLink button
and observe the indicator light.
NOTE:
- If the indicator light stays on constantly, programming
is complete and the garage door/device should
activate when the HomeLink button is pushed.
- To program the two remaining HomeLink buttons,
repeat each step for each remaining button. DO NOT
erase the channels.
If you unplugged the garage door opener/device for
programming, plug it back in at this time.
Reprogramming A Single HomeLink Button
(Canadian/Gate Operator)
To reprogram a channel that has been previously trained,
follow these steps:
- Cycle the ignition to the ON/RUN position.
- Push and hold the desired HomeLink button until the
indicator light begins to flash after 20 seconds. Do not
release the button.
- Without releasing the button, proceed with
"Canadian/Gate Operator Programming" step 2 and
follow all remaining steps.
More about «Garage door opener - if equipped»:
Canadian/Gate Operator Programming