Toyota
Dodge Durango
 Service Manual
Transmission and Transfer Case » Removal and installation
Yoke seal replacement

REMOVAL

(1) Raise vehicle.

(2) Mark propeller shaft and axle yoke for alignment reference.

(3) Disconnect and remove propeller shaft.

(4) Remove old seal with Seal Remover C-3985-B (Fig. 77) from overdrive housing.

INSTALLATION

(1) Place seal in position on overdrive housing.

(2) Drive seal into overdrive housing with Seal Installer C-3995-A (Fig. 78).

(3) Carefully guide propeller shaft slip yoke into housing and onto output shaft splines. Align marks made at removal and connect propeller shaft to rear axle pinion yoke.

Fig. 77 Removing Overdrive Housing Yoke Seal Fig. 77 Removing Overdrive Housing Yoke Seal

1 - SPECIAL TOOL C-3985-B

2 - SEAL

Fig. 78 Installing Overdrive Housing Yoke Seal Fig. 78 Installing Overdrive Housing Yoke Seal

1 - SPECIAL TOOL C-3995-A OR C-3972-A

2 - SPECIAL TOOL C-4471

    More about «Removal and installation»:

    Transmission

    Torque converter

    Yoke seal replacement

    Park/neutral position switch

    Gearshift cable

    Governor solenoid and pressure sensor

    Valve body

    Overdrive unit

    Overdrive housing bushing

    Output shaft rear bearing

    Output shaft front bearing

    Dodge Durango Service Manual / Transmission and Transfer Case / Removal and installation / Yoke seal replacement

    Dodge Durango Service Manual

    Categories


    © 2017-2019 Copyright www.dodurango.net
    0.0049