Toyota
Dodge Durango
 Service Manual
Instrument Panel Systems » Diagnosis and testing » Instrument cluster
Turn signal indicator lamp

The diagnosis found here addresses an inoperative turn signal indicator lamp condition. For any other turn signal problem, refer to Turn Signal and Hazard Warning Systems in the Diagnosis and Testing section of Group 8J - Turn Signal and Hazard Warning Systems for further diagnosis. If no turn signal or hazard warning system problem is found, the following procedure will help locate a short or open in the indicator lamp circuit. For complete circuit descriptions, refer to Instrument Cluster in the Contents of Group 8W - Wiring Diagrams.

(1) Disconnect and isolate the battery negative cable. Remove the instrument cluster.

(2) Connect the battery negative cable. Activate the hazard warning system by moving the hazard warning switch button to the On position. Check for battery voltage at the inoperative (right or left) turn signal circuit cavity of the instrument cluster wire harness connector B. There should be a switching (on and off) battery voltage signal. If OK, replace the faulty (right or left) turn signal indicator lamp bulb.

If not OK, repair the open (right or left) turn signal circuit to the turn signal/hazard warning (multi-function) switch as required.

    More about «Instrument cluster»:

    Preliminary diagnosis

    Self-diagnostic test

    Brake warning lamp

    Cluster illumination lamp

    Four-wheel drive lock indicator lamp

    Headlamp high beam indicator lamp

    Low washer fluid warning lamp

    Security lamp

    Turn signal indicator lamp

    Dodge Durango Service Manual / Instrument Panel Systems / Diagnosis and testing / Instrument cluster / Turn signal indicator lamp

    Dodge Durango Service Manual

    Categories


    © 2017-2019 Copyright www.dodurango.net
    0.0027